structure7/room1irrigation

room1irrigation's Issues

Add ds18b20 for panel temp monitoring

Not sure where to place it... maybe just mid-panel. DO THIS TEMPORARY-STYLE. Just cat5 wire soldered into male pins plugged into female headers atop the WeMos. Might not care about long term temps if everything is okay under test.

Play with Blynk multiple devices to see if it plays nice

Obviously don't want multiple projects. Would like to be able to see the hardware status clearly. If I remember, there might be some light code re-writing, but better now than later!

Assign programmable maximum run duration

Count down on auto water, count up on manual water!

Tray 1&2->Tray 2&4

Program mode to start with 2 trays then move next to 2 other trays.

Logging stuff

Blynk: Two devices, one auth. How to tell which is disconnecting

So there's three bad things that can happen:

1. Overflow or some kind of error causes ESP reset.
2. Network dropout causes Blynk disconnect.
3. ESP error causes Blynk disconnect.

What I know:

• The app clearly knows a disconnect happened because it report it!
• The above has something to do with a "heartbeat" that Blynk monitors... I believe local server folks can tweak interval settings for this. Is this something I can tap into?
• This might be my gold (for now): http://docs.blynk.cc/#blynk-firmware-connection-management

The idea:
Monitor each occurrence of Blynk disconnecting, for whatever the reason. Ideally, report this to a vPin like the uptime monitoring seconds are. THIS SHOULD HELP TROUBLESHOOT PROBLEMS.

Side notes:

• I learned that Blynk.disconnect() is a thing. Might need to see if that's something I'd like to play with for some reason.