- Git installed on command line
- Node & NPM installed
- Checkout the project from Bitbucket.
- Run npm install to setup Cartridge & Gulp.
To get started type gulp
in the command line at the project root. The default task runs in development mode, without watch tasks. The following flasg can be used:
--prod
- Run production tasks--watch
- Watch for file changes
The following coding standards should be used for this project:
- Back end standards (TBC)
- Front end standards
This project uses Cartridge, a set of modules that makes up the Code Computerlove gulp setup. This project was created with Cartridge cli, using version 0.1.5 of cartridge on 29/10/2016
The following Cartridge modules are used in this project
[//]: <> (Modules start)
Module | Version | Repo |
---|---|---|
cartridge-copy-assets | 1.0.0 | https://github.com/cartridge/cartridge-copy-assetscartridge-sass |
[//]: <> (Modules end) |
Additional modules can be added with the Cartridge command line tool. To use it you must install it globally using npm.
> npm i -g cartridge-cli
Modules can then be added to the project using npm
> npm install <<module_name>> --save-dev
more details can be found on the Cartridge cli github page