w4mmp/mscc-sf

Repository for the MSCC application for the Multus SDR, LLC. Solidus transceiver.

mscc-sf's Issues

Spectrum / Waterfall display shift in CW mode

The data displayed on the spectrum and waterfall displays shifts to the right by the CW pitch value.

Favorites General selection box not yet implemented

The GEN (general) box is not yet implemented

MSCC Locks up during QRO PWR Calibration

When on Solidus Tab and selecting a band to calibrate QRO power, MSCC locks up. Most bands work OK except when selecting 60M, 12M and 10M MSCC locks up. The only option is to reboot RPi Stew

MFC Functions - Not yet implemented

The following is the list of MFC functions that are not yet implemented.

1. RIT ON-OFF
2. PTT
3. TUNE
4. CW BW
5. HI BW
6. RIT OFFSET
7. FAVS

Volume Mute not sticky

The volume mute button status is not sticky across MSCC restarts.

Click to tune not yet implemented

The click to tune function of the spectrum display is not yet implemented.

Volume attenuation

The volume attenuation does function correctly.

1. The setting is not sticky
2. When changing the speaker volume, the attenuation is reset to full volume (no attenuation).

Frequency step increment selection only goes to 100K

The frequency step selection is currently limited to 100K steps. This will be corrected in a future release.

VFO - Not yet Implemented

The VFO Button function is not yet implemented

mscc crashes when tuned outside of amateur bands

When tuning outside of the assigned amateur bands mscc switches to the GEN band and then can crash when moving in that band.
Another symptom - mscc was on 17m and when tuning down outside of that band it went to 20m and back to 17m then to 20m etc...
Attaching logs grabbed after that crash.
17m-20_crash.tar.gz

Split Function not yet implemented

The SPT Button (split) function is not yet implemented.

Voice / Digital settings not sticky

Only one microphone volume level is set at startup. The the V or D value will be set at start up depending on the last setting of the V/D button.

Auto Frequency Zero does not function

The function to auto zero the frequency does not function. This will be corrected in a future release.

Side tone - side tone pitch does not follow CW pitch selection

The method of changing the pitch of the CW side tone is to select the PITCH in the pitch drop down selector. The side tone pitch does not follow this selection.