wagiminator/attiny13-tinysat

Solar Powered Blinken Lights

TinySat - Solar Powered Blinken Lights

TinySat collects the energy from up to two solar panels (max 6V) and stores it in a 1 Farad super capacitor. The ATtiny13A uses this stored energy to make two LEDs blink - even when the sun is not shining.

• Design Files (EasyEDA): https://easyeda.com/wagiminator/attiny13-tinysat

Hardware

Compiling and Uploading the Firmware

Since there is no ICSP header on the board, you have to program the ATtiny before putting it into the IC socket. The AVR Programmer Adapter can help with this.

If using the Arduino IDE

• Make sure you have installed MicroCore.
• Go to Tools -> Board -> MicroCore and select ATtiny13.
• Go to Tools and choose the following board options:
  • Clock: 128 kHz internal osc.
  • BOD: disabled
  • Timing: Micros disabled
• Connect your programmer to your PC and to the ATtiny.
• Go to Tools -> Programmer and select your ISP programmer (e.g. USBasp).
• Go to Tools -> Burn Bootloader to burn the fuses.
• Open the TinySat sketch and click Upload.

If using the precompiled hex-file

• Make sure you have installed avrdude.
• Connect your programmer to your PC and to the ATtiny.
• Open a terminal.
• Navigate to the folder with the hex-file.
• Execute the following command (if necessary replace "usbasp" with the programmer you use):

  avrdude -c usbasp -p t13 -U lfuse:w:0x3b:m -U hfuse:w:0xff:m -U flash:w:tinysat.hex
  

If using the makefile (Linux/Mac)

• Make sure you have installed avr-gcc toolchain and avrdude.
• Connect your programmer to your PC and to the ATtiny.
• Open a terminal.
• Navigate to the folder with the makefile and the sketch.
• Run PROGRMR=usbasp make install to compile, burn the fuses and upload the firmware (change PROGRMR accordingly).

License

This work is licensed under Creative Commons Attribution-ShareAlike 3.0 Unported License. (http://creativecommons.org/licenses/by-sa/3.0/)