wallyzambotti/ovcc

Open Virtual Color Computer

ovcc's Issues

Seg fault when trying to save config or load a cart.

I just compiled agar and ovcc from source and installed it. It boots with extended color basic 2.0

but when I try to load a cart or save config, it crashes with a seg fault.

Distributor ID: Ubuntu
Description: Ubuntu 18.04.5 LTS
Release: 18.04
Codename: bionic

5.4.0-74-generic #83~18.04.1-Ubuntu SMP Tue May 11 16:01:00 UTC 2021 x86_64 x86_64 x86_64 GNU/Linux

Nice! I see it is based on a 1.4x version of VCCE. Updates?

The VCCE project is now over v2.10x. Are those improvements tracked in this version?

Ovcc will not load the ini file correctly.

I loaded the mpi and then added a floppy drive, a hard drive and the becker port and then saved the configuration.
The config file seems to have been saved correctly but ovcc does not load it from the command line nor will it load it
from the menu.

makefile issue

Needed to change LIBS = $(SDLLIB) $(AGARLIB) to LIBS = $(AGARLIB) $(SDLLIB) to get link phase to work

vertical sync

CLOCK.TGZ
I have a piece of code that uses:
vwait: lda $ff02 loop: lda $ff03 bpl loop rts
to operate a test clock. It appears that it is seeing approximately 1 interrupt in 15 as compared to an actual coco3.