借鉴
This library is to simplify the validation and handling of E1.31 sACN (DMX over Ethernet) traffic on Arduino ESP8266 and ESP32 based platforms. It supports both Unicast and Multicast configurations, exposing the full E1.31 packet to the user. If you require support for traditional Arduino devices or polling modes, please refer to the E131 library from which this project was derived from.
Development is always done against the latest git pulls for the ESP8266 and ESP32 cores. If you are experiencing issues with your current Arduino core, consider updating it.
- Adruino for ESP8266 - Arduino core for ESP8266
- ESPAsyncUDP - Asynchronous UDP Library
- Arduino for ESP32 - Arduino core for ESP32
- All incoming E1.31 packets are put into a ring buffer once validated. You access incoming packets by checking the ring buffer and pulling packets as needed.
- WiFi connection attempts will timeout after 10 seconds if a successful connection has not been established.
WIFI_CONNECT_TIMEOUT
can be changed inESPAsyncE131.h
.
ESPAsyncE131(uint8_t buffers = 1)
: Creates a new ESPAsyncE131 instance and allocates a ring buffer with X buffer slots. You'll want at least 1 buffer for each Universe that may reach your device.
bool begin(e131_listen_t type, uint16_t universe = 1)
: This should be called from withinsetup()
or whenever you need to re-configure your E1.31 listener. Validtype
s areE131_UNICAST
andE131_MULTICAST
.universe
is optional and only used for Multicast configuration. Returns true if successful.bool isEmpty()
: Returns if the internal ring buffer is emptyvoid *pull(e131_packet_t *packet)
: Pulls oldest packet from the ring buffer and copies it topacket
e131_stats_t stats
: E1.31 Statistics
- Latest code: http://github.com/forkineye/ESPAsyncE131
- Other Stuff: http://forkineye.com