GUI for the Debugger for I2c and UART device. Intended to work on raspberry pi.
- python3
- tkinter (usually pre-installed with python 3 already)
GPIO12 <-> TX
GPIO13 <-> RX
and Ground to any Ground
Click run_pi.sh
on Raspberry pi (may need to change permission first via chmod command), and in prompted window, click "excute"
Or terminal commands
python3 main.py
Or in windows, click run.
8-4-2022
Initial version. Shows the simple layout.
8-12-2022
Finish UART. Improve interface. Add documentation
config.py
Save the configuration values constants. Intend for fast config.
main.py
Main file. Display and control