Shell script to install a Rupaya Masternode on a Linux server running Ubuntu 16.04. Use it on your own risk.
wget -q https://raw.githubusercontent.com/zoldur/rupaya/master/rupaya_install.sh
bash rupaya_install.sh
After the MN is up and running, you need to configure the desktop wallet accordingly. Here are the steps for Windows Wallet
- Open the Rupaya Coin Desktop Wallet.
- Go to RECEIVE and create a New Address: MN1
- Send 10000 Rupaya to MN1.
- Wait for 15 confirmations.
- Go to Tools -> "Debug console - Console"
- Type the following command: masternode outputs
- Go to ** Tools -> "Open Masternode Configuration File"
- Add the following entry:
Alias Address Privkey TxHash Output_index
- Alias: MN1
- Address: VPS_IP:PORT
- Privkey: Masternode Private Key
- TxHash: First value from Step 6
- Output index: Second value from Step 6
- Save and close the file.
- Go to Masternode Tab. If you tab is not shown, please enable it from: Settings - Options - Wallet - Show Masternodes Tab
- Click Update status to see your node. If it is not shown, close the wallet and start it again. Make sure the wallet is unlocked.
- Go to Masternode Tab, select your MN and click Start Alias. Alternatively open Debug Console and type:
startmasternode "alias" "0" "MN1"
rupaya-cli mnsync status
rupaya-cli getinfo
rupaya-cli masternode status #This command will show if your masternode is running or not.
Also, if you want to check/start/stop Rupaya , run one of the following commands as root:
systemctl status Rupaya #To check the service is running.
systemctl start Rupaya #To start Rupaya service.
systemctl stop Rupaya #To stop Rupaya service.
systemctl is-enabled Rupaya #To check whetether Rupaya service is enabled on boot or not.
Any donation is highly appreciated.
RUPX: 7PjC8QupnXGWpL6YFBfCTboBvFGdWjLYnf
BTC: 3MQLEcHXVvxpmwbB811qiC1c6g21ZKa7Jh
ETH: 0x39d10fe57611c564abc255ffd7e984dc97e9bd6d
LTC: LNZpK4rCd1JVSB3rGKTAnTkudV9So9zexB