Windows batch file wont run

[GoogleCodeExporter]

Windows batch file wont run

[GoogleCodeExporter]

Hi there - Did you install the Atmel Flip program? What OS are you running? Is 
it the 32 or 64 bit version?  If it's showing up as the ATmega16U2, that's what 
it should show up as in DFU mode.

Original comment by [email protected] on 17 Oct 2012 at 8:31

• Added labels: ****
• Removed labels: ****

[GoogleCodeExporter]

Ive encountered this...

Im assuming your trying this on the "UNO". If you are having problems getting 
the Arduino board to show as being in DFU mode then it could be that you are 
using an "R1" version of the "UNO". flip the board over and if you dont see 
"R2" or "R3" Then its a Revision 1 board and requires an extra step to place it 
in "DFU" mode.

Go to this site:
https://www.virtuabotix.com/?p=673

half way down under the heading "For version One only" is possibly all you need 
to sort this issue.

Original comment by [email protected] on 4 Jan 2013 at 7:02

• Added labels: ****
• Removed labels: ****

[GoogleCodeExporter]

I have the same problem with REV 3.
What can I do ? 

Original comment by [email protected] on 29 May 2014 at 11:54

• Added labels: ****
• Removed labels: ****

[GoogleCodeExporter]

Plus I'm unable to go back into Arduino mode.
The batch says : "Atlibusbdfu : 3 EB 2FF7" no device present FAIL couldnot open 
sb device.
I can't use my arduino anymore for now.

Original comment by [email protected] on 29 May 2014 at 11:57

• Added labels: ****
• Removed labels: ****