ccadic/esp32-s2-devboardtft

Esp32-S2 dev board with 240x240 IPS display

esp32-s2-devboardtft's Issues

Demo code?

Will you please post the example code that's shipped with the USB-C variant? The ST7789 display code example in this GitHub repo is not working on my board. Do you have the pin out diagram for this new version?

USB doesn't properly enumerate

Plug the MORPEsp32 in to USB and ...

 % ls -l /dev/*usb*
crw-rw-rw-  1 root  wheel    9,   5 Aug  9 17:45 /dev/cu.usbmodem01
crw-rw-rw-  1 root  wheel    9,   4 Aug  9 17:45 /dev/tty.usbmodem01
% 

But those are not ports that esptool can work with.

esptool.py v3.0-dev
Serial port /dev/cu.usbmodem01
Connecting....Traceback (most recent call last):
  File "esptool.py", line 3969, in <module>

  File "esptool.py", line 3962, in _main
  File "esptool.py", line 3552, in main
  File "esptool.py", line 519, in connect
  File "esptool.py", line 499, in _connect_attempt
  File "esptool.py", line 438, in sync
  File "esptool.py", line 402, in command
  File "serial/serialutil.py", line 368, in timeout
  File "serial/serialposix.py", line 326, in _reconfigure_port
serial.serialutil.SerialException: Could not configure port: (6, 'Device not configured')
Failed to execute script esptool
An error occurred while uploading the sketch

Also, not having a board definition available for Arduino makes programming this board rather hard. Any plans to actually support this board properly?

No boot switch on USB-C version

I am trying to flash the USB-C version but there is no boot switch. The board is not recognized by my Mac. There's some sort of JST connector where the documentation says a boot switch should be. Is there updated documentation for this version? I am flashing via arduino IDE on Mac OSX 10.15.