ccadic/esp32-s2-devboardtft

Esp32-S2 dev board with 240x240 IPS display

esp32-s2-devboardtft's Issues

USB doesn't properly enumerate

Plug the MORPEsp32 in to USB and ...

 % ls -l /dev/*usb*
crw-rw-rw-  1 root  wheel    9,   5 Aug  9 17:45 /dev/cu.usbmodem01
crw-rw-rw-  1 root  wheel    9,   4 Aug  9 17:45 /dev/tty.usbmodem01
% 

But those are not ports that esptool can work with.

esptool.py v3.0-dev
Serial port /dev/cu.usbmodem01
Connecting....Traceback (most recent call last):
  File "esptool.py", line 3969, in <module>

  File "esptool.py", line 3962, in _main
  File "esptool.py", line 3552, in main
  File "esptool.py", line 519, in connect
  File "esptool.py", line 499, in _connect_attempt
  File "esptool.py", line 438, in sync
  File "esptool.py", line 402, in command
  File "serial/serialutil.py", line 368, in timeout
  File "serial/serialposix.py", line 326, in _reconfigure_port
serial.serialutil.SerialException: Could not configure port: (6, 'Device not configured')
Failed to execute script esptool
An error occurred while uploading the sketch

Also, not having a board definition available for Arduino makes programming this board rather hard. Any plans to actually support this board properly?

No boot switch on USB-C version

I am trying to flash the USB-C version but there is no boot switch. The board is not recognized by my Mac. There's some sort of JST connector where the documentation says a boot switch should be. Is there updated documentation for this version? I am flashing via arduino IDE on Mac OSX 10.15.

Demo code?

Will you please post the example code that's shipped with the USB-C variant? The ST7789 display code example in this GitHub repo is not working on my board. Do you have the pin out diagram for this new version?