gjorgjevikj/hlk_ld2410

Arduino library for the Hi-Link LD2410 24Ghz FMCW radar sensor

hlk_ld2410's Issues

Question

Hello, this isn't an issue, but I don't think there's any way to communicate with you outside of this section. Since I'm working on this as an amateur, I was very pleased to see that you shared a library for the LD2410 sensor for the ESP32. However, as far as I understand, it adjusts some parameters on the sensor to read the data correctly at the initial setup and then transfers the sensor data to the serial monitor. But there are so many columns that, since I'm not a programmer, I can't manage to simplify this code right now (it seems like all the programming skills have been used :) ). Basically, I want to open the LEDs in my wardrobe at the lowest level at a certain distance, and then, of course, fully open them when I get closer. All the documents I found were prepared for Home Assistant, so this code prepared for the ESP32 is very valuable to me. I would appreciate it if you could guide me.