Running glasgow applets fails on first try after device plug-in

[thasti]

Running glasgow applets fails on first try after device plug-in

[attie]

Where did your Glasgow come from? (self build / me?)

Please could you try running the following?

glasgow flash

[thasti]

Hi Attie. This indeed is one from the batch you made. I confirm that after running glasgow flash, the issue disappears. Now, the glasgow already enumerates fully (i.e. as Glasgow Debug Tool) on the initial plug-in - not only after launching the glasgow run command.

So now I'm not sure if "device is being used without firmware in flash" is a valid use case or not, and therefore whether this issue is actually one or not.

[attie]

Thanks for confirming - I tried to be careful and flash all boards, so I'm surprised you needed to do that step.... my apologies either way.

This is a valid use-case, and it should load firmware and "just work" on the first run... I have a feeling there is already a ticket about this, so I'll look through later and link / close as necessary.

[attie]

This seems to be similar in behaviour to / the same as #239...

[whitequark]

On Linux, Glasgow uses hotplug detection since it's available in libusb, so #239 shouldn't apply...

[whitequark]

To investigate this further I would need verbose logs from glasgow -vvv and also timestamped dmesg. Let me know if this is something you can still reproduce, please.

[whitequark]

No response from reporter for a few months; closing.