me-no-dev/esp32lepton

Library for connecting Flir Lepton modules to ESP32

esp32lepton's Issues

Lepton 3.5 on Sparkfun ESP32 dev board

Hi @me-no-dev ,

I have connected Lepton 3.5 on Sparkfun ESP32 dev board and printing min, max and center temperature pixel values on a Serial monitor (Arduino IDE). I am getting 8 frames per second. That is a good sign so far, given the maximum frame rate you could get out of Lepton 3.5 is 9Hz.

Now, I want to print 160*120 pixels on my serial monitor. Can you suggest where and how I should implement that? I'd appreciate your response.

Thanks,
Akshay

Lepton 3.5

Hello, have you tried using your code with lepton 3.5?

program is stuck on the "Calibrating..." page.

Hello, I am trying to implement this code on my M5Stack Core. But my program is stuck on the "Calibrating..." page. I used a logic analyzer to capture the waveform of the VOSPI and it seems that the FLIR is working properly. I have used a jumper to connect FLIR's VOSPI to a different SPI bus than the Core's screen. In addition, I am using the Lepton 3.0 module, there is no telemetry function. So I set the Lepton mode to LEPTON_FORMAT_RAW in the program. But it still doesn't work, do you have any ideas?