Firmware X-Cube-USB-PD for STM32F0 Nucleo board (support USB Type-C and USB PD) -> to be used with Evaluation Kit named : P-NUCLEO-USB002 (based on STUSB1602 controller), or P-NUCLEO-USB001 (Discrete)
(folder: STM32CubeExpansion_USBPD_F0)
USB type-C (USB-C) and USB Power Delivery (USB-PD) controller based on STM32
This is the firmware using STM32 and GPIO pins to behave as a USB Type-C + PD controller.
No specific USB-PD IC is required. Everything is managed by software. Making this discrete solution a low cost USB-PD controller. Just few external component are required like resitors, capacitors, and Mosfets.
This solution from the silicon provider (STMicro) has been certified by the official USB organisation (USB-IF: USB implementer forum). It only works on STM32 microcontroller (ARM Cortex-M based).
- Development board: P-NUCLEO-USB002 (contains NUCLEO-F072RB Board + MB1303 board)
Devices :- Embedded Controller: STM32F072 (runs the USB-PD stack)
- Analog Front End: STUSB1602 USB-PD controller (high voltage tolerant 28V)
Provider: STMicroelectronics
Note: NUCLEO-F072RB is the Nucleo board.
MB1303 is the Xpansion board containing STUSB1602, to connect on top of the Nucleo board.
- Development board: P-NUCLEO-USB001 (contains NUCLEO-F072RB Board + MB1257 board)
Devices :- Embedded Controller: STM32F072 (runs the USB-PD stack)
- Analog Front End: Discrete implementation with several external components
Provider: STMicroelectronics
X Cube USB PD
Discrete or STUSB1602 solution
React
Typescript
Django
Laravel
Facebook
Microsoft
Google
Alibaba
D3
Tencent