ruisantosdotme/arduino-esp32-camerawebserver

CameraWebServer for ESP32-CAM in Arduino IDE

arduino-esp32-camerawebserver's Issues

ov7670

hi
how work with ov7670 without fifo

Where is the code for startCameraServer()?

Hello;

I was reading the .ino file, and I see a reference to startCameraServer() but, I can't locate where this function is defined. Please help!

Thanks,

Pratap

What is the frame rate of the wifi?

hi @RuiSantosdotme , have you ever tested the fps?

How can I save camera settings to survive power cycle?

How can I save settings applied in the Webinterface, e.h. H-Flip=On & resolution=UXGA, so that they are restored on power loss?
(If power fails and comes back, I’d like to have my settings to be the same than before the power loss).
I can’t find a save button. Is there a way to hard code my own “defaults” in the script files, if yes, where?

Esp

Brownout.

I keep getting brownout fault, but the power supply is stable and I have 3V3 on the 3V3 pin..
I have two boards , both with same result.
I only have one FTDI adapter so have not changed that, but scope shows the power supply seems stable
Any ideas please??
Thanks

Terminal monitor shows this Repeating:
Brownout detector was triggered

ets Jun 8 2016 00:22:57

rst:0xc (SW_CPU_RESET),boot:0x13 (SPI_FAST_FLASH_BOOT)
configsip: 0, SPIWP:0xee
clk_drv:0x00,q_drv:0x00,d_drv:0x00,cs0_drv:0x00,hd_drv:0x00,wp_drv:0x00
mode:DIO, clock div:1
load:0x3fff0018,len:4
load:0x3fff001c,len:1100
load:0x40078000,len:9232
load:0x40080400,len:6400
entry 0x400806a8

and Eventually it shows this..

SCCB_Write [ff]=01 failed
SCCB_Write [12]=80 failed
[E][camera.c:1085] esp_camera_init(): Camera probe failed with error 0x20001
Camera init failed with error 0x20001

Changing WiFi credentials post-soldering?

Is there a way to modify the WiFi credentials post-soldering the cam project? For example, when the connection couldn't be established, after several attempts the chip could create its own hotspot allowing to change the credentials for the new WiFi spot?