steinne/remoteid

NodeMCU RemoteID Spoofer

RIDS - Remote ID Spoofer

An ESP8266/NodeMCU Drone RemoteID Spoofer. Built based on work done by sxjack and SpacehuhnTech. I stand on the shoulders of giants.

This spawns 16 different fake drones broadcasting RemoteID, with them all flying in random directions around a particular GPS location.

Do check that whatever device you're using to detect the drones can sniff packets from the air fast enough. If you're using OpenDroneID available on the App Store or Play Store, you'll have to disable scan throttling for your device, and run the app for ~5-10 minutes before all 16 drones are actually "in the air". You may also have to switch off Wi-Fi, disconnecting from your usual local network on your Android device, for the Wi-Fi chip to be able to scan.

Installation

1. You need the Arduino IDE.
2. Open the file RemoteIDSpoofer/RemoteIDSpoofer.ino.
3. Now go to Tools > Boards > Boards Manager, search esp8266 (or esp32 if you're using an ESP32) and install ESP8266 Boards (or esp32 by either vendors).
4. Select your board at Tools > Board > ESP8266 Boards (or esp32). It's most likely the Generic ESP8266 Module.
5. Plug in your device, and select its COM port at Tools > Port.
6. Press upload, or use Ctrl+U.
7. The device should start broadcasting RemoteID packets generated for random flying machines.

Usage

Pro Tip: There is no need to do these steps everytime you use the device, once the parameters are set, they are remembered across power cycles. Configuration is only needed when when parameter change is desired.

1. After the installation steps, connect to the wireless access point ESP_RIDS using the password makkauhijau on any device, a smartphone will work well enough.
2. Go to the website 192.168.4.1 on the connected device.
3. There, input your own GPS coordinates.
4. Start spoofing!

If no GPS coordinates are used within 2 minutes of startup, the device will automatically go into spoofing mode and you will not be able to change the coordinates without a power cycle.

To-Do List (In order of importance)

• ESP32 support
• Make it so drones don't wander away over time (something like new_location = old_location + 0.5 * progress + 0.5 * (home - old_location))
  • Fix resulting motions
• Get time from browser (possibly with this)
• Configurable number of drones in the air
• Save config onboard
• Use valid RIDs and have option to select region
• Automated CI (I have no idea how to do this)
• Get GPS from browser? (Requires SSL certs on frontend)
• Make Frontend look nicer

Disclaimer

This repository and its code are intended for educational purposes only. Neither the ESP8266, nor its SDK were meant or built for such purposes. Bugs can occur!

It is also illegal to be broadcasting fake RemoteID packets in public airspace, in the same way that spoofing ADS-B packets is illegal. Whatever manner you wish to use this on is at your own discretion, we don't take any responsibility for what you do with this software.